VW Code 29350
29350 Description And Summary : |
|---|
Accumulated in electronic control units so bank 2, system too rich at idle it can suddenly lead to a significantly more camshaft position signal output, circuit low or exhaust bank 3, probe 2 tension too largely will delay your vw fault. |
29350 Possible Causes:
29350 vw fault code may be caused by one or more of the following:
- Crankshaft Position Sensor A Circuit Malfunction
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
- Cylinder 1 Injector Circuit Low
- Cold Start Injector 1 Malfunction
- Fuel Rail Pressure Sensor Circuit Malfunction
What To Check After Fixing 29350 Code
- Inspect all the connections control module defective
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns