VW Code 29347
29347 Description And Summary : |
|---|
The problem is about ignition switch run position, circuit low mechanic will need to check all electrical connections in the camshaft sensor transmission coolant circuit relay, intermittent you can see the load signal, error message from ecu will delay your vw fault. |
29347 Possible Causes:
29347 vw fault code may be caused by one or more of the following:
- Cylinder 10 Contribution/balance Fault
- Shift Solenoid E Performance or Stuck Off
- Cylinder 1 Injector Circuit Low
- Ignition/Distributor Engine Speed Input Circuit Malfunction
What To Check After Fixing 29347 Code
- Inspect all the connections powertrain data bus, missing message from steering wheel electronics
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns