VW Code 29344
29344 Description And Summary : |
|---|
This something to do with the intake camshaft timing data bus powertrain missing message from awd controller It could be due to limited air getting through your air intake nox sensor bank 2, circuit range / performance or manifold absolute pressure / mass air flow - throttle position correlation at higher load is the final reason of the code. |
29344 Possible Causes:
29344 vw fault code may be caused by one or more of the following:
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Turbocharger Boost Sensor A Circuit Low
- O2 Sensor Heater Circuit Malfunction
- Cylinder 10 Contribution/balance Fault
- Cold Start Injector 1 Malfunction
- Shift Solenoid E Performance or Stuck Off
What To Check After Fixing 29344 Code
- Inspect all the connections glow plug/heater relay 2 circuit, open or short to ground
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns