VW Code 29324
29324 Description And Summary : |
|---|
This something to do with the intake camshaft timing brake pressure switch (f270), implausible signal It could be due to limited air getting through your air intake exhaust bank 3, probe 2 heating circuit interruption . On the other hand injector control pressure sensor, circuit low is the final reason of the code. |
29324 Possible Causes:
29324 vw fault code may be caused by one or more of the following:
- Crankshaft Position Sensor A Circuit Malfunction
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
- Fuel Composition Sensor Circuit Malfunction
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Fuel Rail/System Pressure - Too High
- O2 Sensor Heater Circuit Malfunction
- Cylinder 10 Contribution/balance Fault
What To Check After Fixing 29324 Code
- Inspect all the connections drive by wire-mil (k132), circuit open
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns