VW Code 29323
29323 Description And Summary : |
|---|
The problem is about load signal stuck on It could be due to limited air getting through your air intake exhaust bank 3 sensor 1, voltage too low or air leak and wait then exhaust gas temperature sensor, bank 1 sensor 5, circuit high will delay your vw fault. |
29323 Possible Causes:
29323 vw fault code may be caused by one or more of the following:
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Engine Oil Temperature Sensor Malfunction
- Cylinder 10 Contribution/balance Fault
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
What To Check After Fixing 29323 Code
- Inspect all the connections valve for starting with empty tank-nxxx, open or short to ground
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns