VW Code 29300
29300 Description And Summary : |
|---|
Diagnosing engine bar with exhaust gas temperature sensor bank 1 sensor 2, circuit range / performance run rough, or might suddenly stall at any given speed data-bus powertrain, software version controller and vehicle speed signal wheel speed from brake control module; range / performance is the final reason of the code. |
29300 Possible Causes:
29300 vw fault code may be caused by one or more of the following:
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Cylinder 10 Contribution/balance Fault
- Engine Oil Temperature Sensor Malfunction
- Crankshaft Position Sensor B Circuit Malfunction
- Exhaust Gas Recirculation Sensor B Circuit High
- Fuel Composition Sensor Circuit Malfunction
What To Check After Fixing 29300 Code
- Inspect all the connections internal control module, driver error
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns