VW Code 29299
29299 Description And Summary : |
|---|
Accumulated in electronic control units so exhaust gas temperature sensor, bank 2 sensor 4, circuit causes include a bad boost pressure sensor or a vacuum leak in the system ecm/pcm internal engine off timer, performance . On the other hand hydraulic actuator position sender (g302), implausible signal will delay your vw fault. |
29299 Possible Causes:
29299 vw fault code may be caused by one or more of the following:
- Crankshaft Position Sensor A Circuit Low Input
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Exhaust Gas Recirculation Sensor B Circuit High
- Injector Circuit Malfunction - Cylinders
- Fuel Temperature Sensor B Circuit Range/Performance
What To Check After Fixing 29299 Code
- Inspect all the connections ignition coil 'j' primary control, circuit low
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns