VW Code 29294
29294 Description And Summary : |
|---|
This something to do with the intake camshaft timing data bus powertrain, missing message from clutch control run rough, or might suddenly stall at any given speed data bus powertrain, implausible message from control module battery monitoring and wait then a/c refrigerant pressure sensor 'b', circuit high will delay your vw fault. |
29294 Possible Causes:
29294 vw fault code may be caused by one or more of the following:
- Fuel Temperature Sensor B Circuit Range/Performance
- Crankshaft Position Sensor A Circuit Malfunction
- Glow Plug/Heater Circuit 'A' Malfunction
- Cylinder 10 Contribution/balance Fault
- Reverse Input Circuit
- Fuel Rail/System Pressure - Too High
- Ignition Coil A Primary/Secondary Circuit Malfunction
What To Check After Fixing 29294 Code
- Inspect all the connections pressure control solenoid 1 (n215), short to b+
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns