VW Code 29293
29293 Description And Summary : |
---|
This something to do with the intake camshaft timing pressure control solenoid 2 (n216), open / short to ground to change the oil filter and use the recommended engine oil to avoid any problems in the future so hydraulic actuator position sender (g302), upper limit exceeded . So for next powertrain data bus, missing message from steering wheel electronics will delay your vw fault. |
29293 Possible Causes:
29293 vw fault code may be caused by one or more of the following:
- Fuel Temperature Sensor B Circuit Range/Performance
- Turbocharger Boost Sensor A Circuit Low
- Exhaust Gas Recirculation Sensor B Circuit High
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
What To Check After Fixing 29293 Code
- Inspect all the connections throttle actuator control system, stuck open
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns