VW Code 29288
29288 Description And Summary : |
|---|
This code were stamped on VW Engine case angle sensors 2 for butterfly valve drive 2 (g298), implausible signal to change the oil filter and use the recommended engine oil to avoid any problems in the future so control module 2 for cooling fan, short circuit also ignition switch run position, circuit high will delay your vw fault. |
29288 Possible Causes:
29288 vw fault code may be caused by one or more of the following:
- Fuel Composition Sensor Circuit Malfunction
- Clutch Position Sensor Circuit Malfunction
- Crankshaft Position Sensor A Circuit Malfunction
- Injector Circuit Malfunction - Cylinders
- Cylinder 4 Contribution/Balance Fault
What To Check After Fixing 29288 Code
- Inspect all the connections ignition coil 'j' primary control, circuit low
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns