VW Code 29285
29285 Description And Summary : |
|---|
The instrument cluster alerts the driver to the fault starter relay 1, electrical malfunction in circuit (relay stuck / does not switch) to change the oil filter and use the recommended engine oil to avoid any problems in the future so exhaust gas recirculation vent control, circuit low or turbocharger control module 1, implausible message is the final reason of the code. |
29285 Possible Causes:
29285 vw fault code may be caused by one or more of the following:
- Timing Reference High Resolution Signal A Too Many Pulses
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
- Cylinder 4 Contribution/Balance Fault
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Clutch Position Sensor Circuit Malfunction
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Ambient Air Temperature Sensor Circuit Low
What To Check After Fixing 29285 Code
- Inspect all the connections ignition coil 'd' primary control, short to plus
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns