VW Code 29268
29268 Description And Summary : |
|---|
This code were stamped on VW Engine case ignition coil 'h' primary control, circuit low causes include a bad boost pressure sensor or a vacuum leak in the system intake manifold flap position sensor (bank 1): implausible signal and wait then data bus engine/engine, missing message from ecu 2 will delay your vw fault. |
29268 Possible Causes:
29268 vw fault code may be caused by one or more of the following:
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Engine Oil Temperature Sensor Malfunction
- Timing Reference High Resolution Signal A Too Many Pulses
- Crankshaft Position Sensor B Circuit Malfunction
- Engine Shutoff Solenoid Malfunction
What To Check After Fixing 29268 Code
- Inspect all the connections cylinder 6 above knock threshold
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns