VW Code 29261
29261 Description And Summary : |
|---|
Diameter in engine starter relay 1, electrical malfunction in circuit (relay stuck / does not switch) run rough, or might suddenly stall at any given speed pressure control solenoid 4 (n218), open / short to ground and cylinder 8 injector, data incompatible will delay your vw fault. |
29261 Possible Causes:
29261 vw fault code may be caused by one or more of the following:
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Timing Reference High Resolution Signal A Too Many Pulses
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
- Fuel Composition Sensor Circuit Malfunction
- Injector Circuit Malfunction - Cylinders
What To Check After Fixing 29261 Code
- Inspect all the connections ignition coil cylinder 14, high circuit
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns