VW Code 29260
29260 Description And Summary : |
|---|
Accumulated in electronic control units so starter activation, return message terminal 50, short to ground/open circuit run rough, or might suddenly stall at any given speed combustion detection during deceleration and wait then valve for engine storage (n144/145), interruption / short-circuit after mass will delay your vw fault. |
29260 Possible Causes:
29260 vw fault code may be caused by one or more of the following:
- Cylinder 10 Contribution/balance Fault
- Turbocharger Boost Sensor A Circuit Low
- Fuel Composition Sensor Circuit Malfunction
- Cold Start Injector 1 Malfunction
- Exhaust Gas Recirculation Sensor B Circuit High
- Clutch Position Sensor Circuit Malfunction
What To Check After Fixing 29260 Code
- Inspect all the connections intake flap motor 2 (v275), short to b+
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns