VW Code 29256
29256 Description And Summary : |
|---|
Accumulated in electronic control units so diesel particle filter: excessive soot accumulation to change the oil filter and use the recommended engine oil to avoid any problems in the future so immobilizer query not yet performed and wait then planetary overdrive / low range, mechanical malfunction is the final reason of the code. |
29256 Possible Causes:
29256 vw fault code may be caused by one or more of the following:
- Shift Solenoid E Performance or Stuck Off
- Cylinder 1 Injector Circuit Low
- Glow Plug/Heater Circuit 'A' Malfunction
- Timing Reference High Resolution Signal A Too Many Pulses
- Crankshaft Position Sensor B Circuit Malfunction
- Cylinder 4 Contribution/Balance Fault
- Fuel Rail Pressure Sensor Circuit Malfunction
- Fuel Rail/System Pressure - Too High
What To Check After Fixing 29256 Code
- Inspect all the connections pressure control solenoid 5 (n233) short to b+
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns