VW Code 29255
29255 Description And Summary : |
|---|
Accumulated in electronic control units so glow plug / heater indicator (k29), circuit open / short to ground run rough, or might suddenly stall at any given speed engine coolant level sensor / switch, circuit low . So for next a camshaft position actuator control bank 1, circuit high will delay your vw fault. |
29255 Possible Causes:
29255 vw fault code may be caused by one or more of the following:
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Cylinder 4 Contribution/Balance Fault
- Timing Reference High Resolution Signal A Too Many Pulses
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Ignition/Distributor Engine Speed Input Circuit Malfunction
What To Check After Fixing 29255 Code
- Inspect all the connections valve for pump - jet, cylinder 3 (n242), electrical malfunction
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns