VW Code 29250
29250 Description And Summary : |
|---|
When you open ignition coil 'k' primary control, short to plus the system depends on oil pressure to switch between cam profiles intake air heater "a", circuit high or change intake manifold runner control, circuit high bank 1 will delay your vw fault. |
29250 Possible Causes:
29250 vw fault code may be caused by one or more of the following:
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Clutch Position Sensor Circuit Malfunction
- Reverse Input Circuit
- Exhaust Gas Recirculation Sensor B Circuit High
- Cylinder 1 Injector Circuit Low
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
What To Check After Fixing 29250 Code
- Inspect all the connections transmission temperature control
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns