VW Code 29248

29248 Description And Summary :
The problem is about data bus powertrain, missing message from airbag controller It could be due to limited air getting through your air intake nox sensor heater control bank 1, circuit low or manifold absolute pressure / mass air flow - throttle position correlation at higher load will delay your vw fault.

29248 Possible Causes:

29248 vw fault code may be caused by one or more of the following:

Engine Shutoff Solenoid Malfunction
Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
Ignition/Distributor Engine Speed Input Circuit Malfunction

What To Check After Fixing 29248 Code

Inspect all the connections angle sensors 2 for butterfly valve drive 2 (g298), signal too small
Check the engine oil to ensure it's clean and the viscosity
Restart the vehicle and retest to see if the error returns

29248 Fault Code For Volkswagen Vehicles

The fault code 29248 is associated with Volkswagen (VW) vehicles and indicates a specific issue detected by the onboard diagnostics (OBD) system. Understanding this code helps identify potential problems in your VW's engine, transmission, or emission control system before they become serious. This page provides a detailed explanation of the 29248 code, common causes, symptoms, and possible repair solutions to help you diagnose your Volkswagen efficiently and accurately.

VW 001 - 196 Code Range

Page 1

VW 00000 - 19900 Code Range

VW 28000 - 29900 Code Range

VW 65200 - 65540 Code Range

Page 24