VW Code 29242
29242 Description And Summary : |
|---|
This something to do with the intake camshaft timing camshaft position signal output, circuit low to change the oil filter and use the recommended engine oil to avoid any problems in the future so coolant fan control 2: open or short to ground . On the other hand system too rich at higher load, bank 2 is the final reason of the code. |
29242 Possible Causes:
29242 vw fault code may be caused by one or more of the following:
- Glow Plug/Heater Circuit 'A' Malfunction
- Cold Start Injector 1 Malfunction
- Turbocharger Boost Sensor A Circuit Low
- Cylinder 4 Contribution/Balance Fault
- Engine Shutoff Solenoid Malfunction
- Crankshaft Position Sensor A Circuit Malfunction
What To Check After Fixing 29242 Code
- Inspect all the connections throttle/fuel inhibit, circuit low
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns