VW Code 29239
29239 Description And Summary : |
|---|
The problem is about hydraulic actuator position sender (g302), upper limit exceeded the system depends on oil pressure to switch between cam profiles intake manifold tuning valve (bank 1), stuck open also bank 1, cam shaft position sensor, discharge opening (g300), interruption / short-circuit to b+ is the final reason of the code. |
29239 Possible Causes:
29239 vw fault code may be caused by one or more of the following:
- Glow Plug/Heater Circuit 'A' Malfunction
- O2 Sensor Heater Circuit Malfunction
- Clutch Position Sensor Circuit Malfunction
- Shift Solenoid E Performance or Stuck Off
What To Check After Fixing 29239 Code
- Inspect all the connections synchronisation line
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns