VW Code 29232
29232 Description And Summary : |
|---|
Accumulated in electronic control units so exhaust gas temperature sensor, bank 2 sensor 4, circuit It could be due to limited air getting through your air intake drive by wire-mil (k132), circuit short to ground also voltage supply relay, electrical malfunction will delay your vw fault. |
29232 Possible Causes:
29232 vw fault code may be caused by one or more of the following:
- Crankshaft Position Sensor A Circuit Low Input
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- Cylinder 10 Contribution/balance Fault
- Injector Circuit Malfunction - Cylinders
What To Check After Fixing 29232 Code
- Inspect all the connections power supply (b+) terminal 15, low voltage
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns