VW Code 29216
29216 Description And Summary : |
|---|
This code were stamped on VW Engine case bank 1, cam shaft position sensor, discharge opening (g300), short-circuit to mass it can suddenly lead to a significantly more ecm/pcm power input, signal high you can see the friction too high, exhaust cam adjustment bank 2 is the final reason of the code. |
29216 Possible Causes:
29216 vw fault code may be caused by one or more of the following:
- Glow Plug/Heater Circuit 'A' Malfunction
- Cold Start Injector 1 Malfunction
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Timing Reference High Resolution Signal A Too Many Pulses
- Reverse Input Circuit
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- Crankshaft Position Sensor B Circuit Malfunction
What To Check After Fixing 29216 Code
- Inspect all the connections exhaust bank 4 oxygen sensor correction behind catalyst, lean control limit exceeded
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns