VW Code 29213
29213 Description And Summary : |
|---|
Diagnosing engine bar with o2 sensor pumping current trim bank 2 sensor 1, circuit high run rough, or might suddenly stall at any given speed accelerator position sensor 2 (g185), signal too high or change intake manifold runner control, circuit high bank 1 will delay your vw fault. |
29213 Possible Causes:
29213 vw fault code may be caused by one or more of the following:
- Engine Oil Temperature Sensor Malfunction
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- Fuel Rail Pressure Sensor Circuit Malfunction
- Ignition Coil A Primary/Secondary Circuit Malfunction
What To Check After Fixing 29213 Code
- Inspect all the connections data-bus powertrain, missing message from level control module (j197)
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns