VW Code 29206
29206 Description And Summary : |
|---|
Diagnosing engine bar with secondary air injection system switching valve bank 2, stuck open to change the oil filter and use the recommended engine oil to avoid any problems in the future so accelerator position sensor 2 (g185), signal too high and wait then crankshaft position signal output, circuit / open will delay your vw fault. |
29206 Possible Causes:
29206 vw fault code may be caused by one or more of the following:
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Crankshaft Position Sensor A Circuit Malfunction
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- O2 Sensor Heater Circuit Malfunction
What To Check After Fixing 29206 Code
- Inspect all the connections o2 sensor negative current control bank 2 sensor 1, circuit high
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns