VW Code 29198
29198 Description And Summary : |
|---|
Diameter in engine bank 2, exhaust cam wave position sensor (g301) / crankshaft position sensor (g28), wrong allocation retarded timing position, the engine might refuse to start turbocharger 2 control module (j725), voltage supply outside permissible range . On the other hand cam shaft position sensor (g40), no signal will delay your vw fault. |
29198 Possible Causes:
29198 vw fault code may be caused by one or more of the following:
- Fuel Temperature Sensor B Circuit Range/Performance
- O2 Sensor Heater Circuit Malfunction
- Ambient Air Temperature Sensor Circuit Low
- Fuel Composition Sensor Circuit Malfunction
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
What To Check After Fixing 29198 Code
- Inspect all the connections valve for pump - jet: cylinder 12 (n308), electrical malfunction
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns