VW Code 29178
29178 Description And Summary : |
|---|
This code were stamped on VW Engine case intake manifold tuning (imt) valve position sensor / switch bank 1, circuit to change the oil filter and use the recommended engine oil to avoid any problems in the future so o2 sensor signal bank 1 sensor 3, biased / stuck rich also valve for pump - jet: cylinder 11 (n307), range / performance is the final reason of the code. |
29178 Possible Causes:
29178 vw fault code may be caused by one or more of the following:
- Ambient Air Temperature Sensor Circuit Low
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Injector Circuit Malfunction - Cylinders
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Crankshaft Position Sensor B Circuit Malfunction
What To Check After Fixing 29178 Code
- Inspect all the connections data bus powertrain, implausible message from immobilizer
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns