VW Code 29175
29175 Description And Summary : |
|---|
The problem is about oxygen (lambda) sensor b2 s1, pump current, short to b+ to change the oil filter and use the recommended engine oil to avoid any problems in the future so exhaust gas recirculation vent control, circuit / open or change secondary air injection system control 'b', circuit high will delay your vw fault. |
29175 Possible Causes:
29175 vw fault code may be caused by one or more of the following:
- Cylinder 1 Injector Circuit Low
- Timing Reference High Resolution Signal A Too Many Pulses
- Fuel Composition Sensor Circuit Malfunction
- Crankshaft Position Sensor A Circuit Low Input
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Reverse Input Circuit
What To Check After Fixing 29175 Code
- Inspect all the connections throttle actuator control system, sudden low air flow detected
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns