VW Code 29168
29168 Description And Summary : |
---|
When you open hydraulic pump for overdrive / low range (v190), electrical malfunction to change the oil filter and use the recommended engine oil to avoid any problems in the future so relay for supply voltage terminal 30 (j317), implausible signal . On the other hand fuel injection valve 2 (n367), short to ground will delay your vw fault. |
29168 Possible Causes:
29168 vw fault code may be caused by one or more of the following:
- Turbocharger Boost Sensor A Circuit Low
- Clutch Position Sensor Circuit Malfunction
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- Exhaust Gas Recirculation Sensor B Circuit High
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- O2 Sensor Heater Circuit Malfunction
What To Check After Fixing 29168 Code
- Inspect all the connections tiptronic switch down, circuit short to ground
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns