VW Code 29157
29157 Description And Summary : |
|---|
When you open fuel cap sensor / switch, circuit range / performance to change the oil filter and use the recommended engine oil to avoid any problems in the future so fuel injection valve 1 (n366), open circuit and wait then altitude adaptation, signal out of tolerance is the final reason of the code. |
29157 Possible Causes:
29157 vw fault code may be caused by one or more of the following:
- Crankshaft Position Sensor B Circuit Malfunction
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Clutch Position Sensor Circuit Malfunction
- O2 Sensor Heater Circuit Malfunction
- Cold Start Injector 1 Malfunction
- Reverse Input Circuit
- Fuel Rail/System Pressure - Too High
What To Check After Fixing 29157 Code
- Inspect all the connections vacuum reservoir pressure sensor, circuit low
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns