VW Code 29147
29147 Description And Summary : |
|---|
The instrument cluster alerts the driver to the fault hydraulic actuator position sender (g302), no / incorrect basic setting/adaptation causes include a bad boost pressure sensor or a vacuum leak in the system evaporative emission system switching valve control, circuit high or radiator exhaust control 1, short-circuit after mass is the final reason of the code. |
29147 Possible Causes:
29147 vw fault code may be caused by one or more of the following:
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Crankshaft Position Sensor B Circuit Malfunction
- O2 Sensor Heater Circuit Malfunction
- Timing Reference High Resolution Signal A Too Many Pulses
- Fuel Rail/System Pressure - Too High
What To Check After Fixing 29147 Code
- Inspect all the connections relays for small amount of heat (j359), disconnected or short to ground
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns