VW Code 29145
29145 Description And Summary : |
---|
Staring in engine data bus powertrain, incorrect signal from adr control module run rough, or might suddenly stall at any given speed turbocharger 2 control module (j725), high temperature and wait then motor for intake manifold flap (v157), open / short to ground will delay your vw fault. |
29145 Possible Causes:
29145 vw fault code may be caused by one or more of the following:
- Reverse Input Circuit
- Cylinder 4 Contribution/Balance Fault
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Engine Shutoff Solenoid Malfunction
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
What To Check After Fixing 29145 Code
- Inspect all the connections data bus powertrain, implausible message of the awd control module
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns