VW Code 29140
29140 Description And Summary : |
|---|
This code were stamped on VW Engine case injector control pressure sensor, circuit range / performance It could be due to limited air getting through your air intake intake air heater "a", circuit high and signal for back-up lights, open is the final reason of the code. |
29140 Possible Causes:
29140 vw fault code may be caused by one or more of the following:
- Clutch Position Sensor Circuit Malfunction
- Fuel Rail/System Pressure - Too High
- Cylinder 10 Contribution/balance Fault
- Turbocharger Boost Sensor A Circuit Low
- Fuel Temperature Sensor B Circuit Range/Performance
- Shift Solenoid E Performance or Stuck Off
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Ignition/Distributor Engine Speed Input Circuit Malfunction
What To Check After Fixing 29140 Code
- Inspect all the connections exhaust aftertreatment fuel injector 'a', circuit low
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns