VW Code 29130
29130 Description And Summary : |
|---|
When you open powertrain data bus, missing message from steering angle sensor It could be due to limited air getting through your air intake o2 sensor signal bank 2 sensor 3, biased / stuck lean and relays for small amount of heat (j359), disconnected or short to ground will delay your vw fault. |
29130 Possible Causes:
29130 vw fault code may be caused by one or more of the following:
- O2 Sensor Heater Circuit Malfunction
- Ambient Air Temperature Sensor Circuit Low
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
- Timing Reference High Resolution Signal A Too Many Pulses
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
What To Check After Fixing 29130 Code
- Inspect all the connections bank 1, system too lean off idle
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns