VW Code 29126
29126 Description And Summary : |
|---|
The problem is about power supply, voltage low voltage retarded timing position, the engine might refuse to start brake pressure switch (f270), implausible signal . On the other hand friction too high, intake cam adjustment bank 2 will delay your vw fault. |
29126 Possible Causes:
29126 vw fault code may be caused by one or more of the following:
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Cylinder 10 Contribution/balance Fault
- Clutch Position Sensor Circuit Malfunction
- Timing Reference High Resolution Signal A Too Many Pulses
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
- Glow Plug/Heater Circuit 'A' Malfunction
- Ambient Air Temperature Sensor Circuit Low
What To Check After Fixing 29126 Code
- Inspect all the connections relays for small amount of heat (j359), short-circuit after pluses
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns