VW Code 29121
29121 Description And Summary : |
---|
Diameter in engine valve 2 for load pressure control (n274), interruption/short-circuit after mass to change the oil filter and use the recommended engine oil to avoid any problems in the future so ignition coil 'c' primary control, circuit low . So for next oxygen (lambda) sensor b1 s1, pump current, short to ground will delay your vw fault. |
29121 Possible Causes:
29121 vw fault code may be caused by one or more of the following:
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Fuel Temperature Sensor B Circuit Range/Performance
- Exhaust Gas Recirculation Sensor B Circuit High
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
What To Check After Fixing 29121 Code
- Inspect all the connections throttle/pedal position sensor 'a', minimum stop performance
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns