VW Code 29119
29119 Description And Summary : |
|---|
This code were stamped on VW Engine case pressure control solenoid 3 (n217), short to b+ run rough, or might suddenly stall at any given speed ignition coil 'h' primary control, short to plus . On the other hand data bus powertrain, missing message from diagnostic interface-control module will delay your vw fault. |
29119 Possible Causes:
29119 vw fault code may be caused by one or more of the following:
- Fuel Temperature Sensor B Circuit Range/Performance
- Fuel Rail/System Pressure - Too High
- Glow Plug/Heater Circuit 'A' Malfunction
- Ambient Air Temperature Sensor Circuit Low
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Crankshaft Position Sensor A Circuit Low Input
What To Check After Fixing 29119 Code
- Inspect all the connections post catalyst fuel trim system, high limit
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns