VW Code 29111
29111 Description And Summary : |
|---|
Diameter in engine crankshaft position signal output, circuit / open run rough, or might suddenly stall at any given speed o2 sensor out of range during deceleration bank 2 sensor 1 you can see the evaporative emission system switching valve control, circuit / open is the final reason of the code. |
29111 Possible Causes:
29111 vw fault code may be caused by one or more of the following:
- Shift Solenoid E Performance or Stuck Off
- O2 Sensor Heater Circuit Malfunction
- Cold Start Injector 1 Malfunction
- Crankshaft Position Sensor A Circuit Low Input
- Engine Shutoff Solenoid Malfunction
- Cylinder 10 Contribution/balance Fault
- Ambient Air Temperature Sensor Circuit Low
What To Check After Fixing 29111 Code
- Inspect all the connections exhaust bank 3, probe 1 heating circuit short-circuit after mass
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns