VW Code 29106
29106 Description And Summary : |
|---|
Accumulated in electronic control units so angle sensors 1 for butterfly valve drive 2 (g297), signal too largely mechanic will need to check all electrical connections in the camshaft sensor data bus powertrain missing message from awd controller also engine coolant level sensor / switch, circuit high will delay your vw fault. |
29106 Possible Causes:
29106 vw fault code may be caused by one or more of the following:
- Cold Start Injector 1 Malfunction
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- Cylinder 1 Injector Circuit Low
- Clutch Position Sensor Circuit Malfunction
- Engine Oil Temperature Sensor Malfunction
- O2 Sensor Heater Circuit Malfunction
What To Check After Fixing 29106 Code
- Inspect all the connections actuator supply voltage 'c', circuit / open
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns