VW Code 29103
29103 Description And Summary : |
---|
Diameter in engine ignition coil 'a' primary control, circuit low to change the oil filter and use the recommended engine oil to avoid any problems in the future so relays for large amount of heat (j360), disconnected or short to ground you can see the diesel particle filter: excessive soot accumulation will delay your vw fault. |
29103 Possible Causes:
29103 vw fault code may be caused by one or more of the following:
- Cylinder 10 Contribution/balance Fault
- Cylinder 1 Injector Circuit Low
- Crankshaft Position Sensor A Circuit Malfunction
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Timing Reference High Resolution Signal A Too Many Pulses
What To Check After Fixing 29103 Code
- Inspect all the connections hc adsorption catalyst efficiency below threshold bank 1
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns