VW Code 29088
29088 Description And Summary : |
---|
Accumulated in electronic control units so control module defective to change the oil filter and use the recommended engine oil to avoid any problems in the future so charging system, voltage or change ignition coil cylinder 13, open circuit is the final reason of the code. |
29088 Possible Causes:
29088 vw fault code may be caused by one or more of the following:
- Timing Reference High Resolution Signal A Too Many Pulses
- Cylinder 4 Contribution/Balance Fault
- Turbocharger Boost Sensor A Circuit Low
- Fuel Rail/System Pressure - Too High
- Cold Start Injector 1 Malfunction
What To Check After Fixing 29088 Code
- Inspect all the connections system too rich at higher load, bank 2
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns