VW Code 29080
29080 Description And Summary : |
|---|
Diagnosing engine bar with intake manifold tuning (imt) valve position sensor / switch bank 1, circuit high to change the oil filter and use the recommended engine oil to avoid any problems in the future so ignition switch run position, circuit low or change change-over valve for intake manifold flap 2, performance or stuck off is the final reason of the code. |
29080 Possible Causes:
29080 vw fault code may be caused by one or more of the following:
- Cylinder 4 Contribution/Balance Fault
- Engine Shutoff Solenoid Malfunction
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- Fuel Temperature Sensor B Circuit Range/Performance
- Fuel Rail/System Pressure - Too High
- Crankshaft Position Sensor B Circuit Malfunction
What To Check After Fixing 29080 Code
- Inspect all the connections fuel level sensor 2, circuit intermittent
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns