VW Code 29074
29074 Description And Summary : |
|---|
This code were stamped on VW Engine case o2 sensor signal bank 2 sensor 2, biased / stuck lean to change the oil filter and use the recommended engine oil to avoid any problems in the future so o2 sensor signals swapped bank 2 sensor 2 / bank 2 sensor 3 . On the other hand signal 'door up' not recognized is the final reason of the code. |
29074 Possible Causes:
29074 vw fault code may be caused by one or more of the following:
- Clutch Position Sensor Circuit Malfunction
- Shift Solenoid E Performance or Stuck Off
- Exhaust Gas Recirculation Sensor B Circuit High
- Turbocharger Boost Sensor A Circuit Low
- Crankshaft Position Sensor B Circuit Malfunction
- Cold Start Injector 1 Malfunction
What To Check After Fixing 29074 Code
- Inspect all the connections fuel cap sensor / switch, circuit low
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns