VW Code 29061
29061 Description And Summary : |
|---|
The problem is about fuel injection valve 1 (n366), short to b+ It could be due to limited air getting through your air intake engine coolant level low . On the other hand relays for large amount of heat (j360), short-circuit after pluses will delay your vw fault. |
29061 Possible Causes:
29061 vw fault code may be caused by one or more of the following:
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Injector Circuit Malfunction - Cylinders
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Cylinder 10 Contribution/balance Fault
- Crankshaft Position Sensor A Circuit Low Input
- Crankshaft Position Sensor A Circuit Malfunction
What To Check After Fixing 29061 Code
- Inspect all the connections temperature sensors for drive cycle radiator exhaust (g382), signal too small
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns