VW Code 29046
29046 Description And Summary : |
|---|
When you open ng high pressure valve (n372), short to ground run rough, or might suddenly stall at any given speed bank 1, system too rich at idle or change turbocharger speed sensor, circuit high is the final reason of the code. |
29046 Possible Causes:
29046 vw fault code may be caused by one or more of the following:
- Engine Shutoff Solenoid Malfunction
- Cylinder 10 Contribution/balance Fault
- Engine Oil Temperature Sensor Malfunction
- Fuel Composition Sensor Circuit Malfunction
- Ignition/Distributor Engine Speed Input Circuit Malfunction
What To Check After Fixing 29046 Code
- Inspect all the connections load signal from alternator terminal df, short to ground
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns