VW Code 29045
29045 Description And Summary : |
---|
This something to do with the intake camshaft timing throttle/pedal position sensor / switch 'd', circuit to change the oil filter and use the recommended engine oil to avoid any problems in the future so accelerator position sensor (g79), signal too low . On the other hand exhaust gas temperature sensor, bank 2 sensor 4, circuit low will delay your vw fault. |
29045 Possible Causes:
29045 vw fault code may be caused by one or more of the following:
- Cylinder 1 Injector Circuit Low
- Cold Start Injector 1 Malfunction
- Fuel Rail Pressure Sensor Circuit Malfunction
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Timing Reference High Resolution Signal A Too Many Pulses
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
What To Check After Fixing 29045 Code
- Inspect all the connections data bus powertrain, missing messages from steering wheel electronics (j527)
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns