VW Code 29041
29041 Description And Summary : |
|---|
This something to do with the intake camshaft timing ignition coil 'f' primary control, short to plus it can suddenly lead to a significantly more diesel particulate filter differential pressure too high bank 2 . On the other hand hydraulic actuator position sender (g302), upper limit exceeded will delay your vw fault. |
29041 Possible Causes:
29041 vw fault code may be caused by one or more of the following:
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Cylinder 1 Injector Circuit Low
- Fuel Temperature Sensor B Circuit Range/Performance
- Fuel Composition Sensor Circuit Malfunction
- Crankshaft Position Sensor A Circuit Low Input
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Glow Plug/Heater Circuit 'A' Malfunction
- Cylinder 10 Contribution/balance Fault
What To Check After Fixing 29041 Code
- Inspect all the connections bank 2 sensor 1, internal resistance implausible
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns