VW Code 29036
29036 Description And Summary : |
|---|
Diagnosing engine bar with a/c request b, circuit high the system depends on oil pressure to switch between cam profiles coolant fan 2 (v177), open circuit and wait then intake manifold runner control, lower stop not reached is the final reason of the code. |
29036 Possible Causes:
29036 vw fault code may be caused by one or more of the following:
- Engine Shutoff Solenoid Malfunction
- O2 Sensor Heater Circuit Malfunction
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Ambient Air Temperature Sensor Circuit Low
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Fuel Temperature Sensor B Circuit Range/Performance
What To Check After Fixing 29036 Code
- Inspect all the connections cam shaft position sensor (g40), signal outside of the tolerance
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns