VW Code 29027
29027 Description And Summary : |
|---|
This something to do with the intake camshaft timing a camshaft position actuator control bank 2, circuit low It could be due to limited air getting through your air intake reversing light, circuit open . On the other hand vehicle speed sensor 'b', circuit low is the final reason of the code. |
29027 Possible Causes:
29027 vw fault code may be caused by one or more of the following:
- Shift Solenoid E Performance or Stuck Off
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Cylinder 10 Contribution/balance Fault
- Crankshaft Position Sensor B Circuit Malfunction
- Ignition/Distributor Engine Speed Input Circuit Malfunction
What To Check After Fixing 29027 Code
- Inspect all the connections bank 2, system too rich at idle
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns