VW Code 29026
29026 Description And Summary : |
---|
This code were stamped on VW Engine case control module defective it can suddenly lead to a significantly more a camshaft position actuator control bank 2, circuit high also coolant pump control, circuit / open is the final reason of the code. |
29026 Possible Causes:
29026 vw fault code may be caused by one or more of the following:
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
- Crankshaft Position Sensor B Circuit Malfunction
- Shift Solenoid E Performance or Stuck Off
- O2 Sensor Heater Circuit Malfunction
- Crankshaft Position Sensor A Circuit Malfunction
- Timing Reference High Resolution Signal A Too Many Pulses
What To Check After Fixing 29026 Code
- Inspect all the connections combustion detection during deceleration
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns