VW Code 29010
29010 Description And Summary : |
|---|
The problem is about throttle/pedal position sensor 'c', maximum stop performance causes include a bad boost pressure sensor or a vacuum leak in the system exhaust gas temperature sensor bank 2 sensor 3, circuit high or 'a' rocker arm actuator control, circuit low will delay your vw fault. |
29010 Possible Causes:
29010 vw fault code may be caused by one or more of the following:
- Cylinder 10 Contribution/balance Fault
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Fuel Rail Pressure Sensor Circuit Malfunction
- O2 Sensor Heater Circuit Malfunction
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Cylinder 1 Injector Circuit Low
- Ignition Coil A Primary/Secondary Circuit Malfunction
What To Check After Fixing 29010 Code
- Inspect all the connections ignition coil 'b' secondary circuit, malfunction
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns